Connecting piece support jack with multi waler cpl.

The connecting piece support jack with multi waler cpl. is part of the general accessories of the multi waler from PASCHAL and enables a quick and safe assembly to a support jack for a formwork height of up to 1.5m. In addition, the assembled support jack can be inclined by 15° in both directions by means of the freely movable multi walers along the connecting plate, which allows you to easily realise demanding projects.

• Consisting of connecting plate, locking pin, tube locking pin and security pin
• Delivered from the factory as a complete part
• Quick and easy assembly
• Few components
• Creates flexibility and increases the range of applications for your multi walers
• Lightweight at just 6.9 kg
• Durable and robust

Application information

The connecting piece support jack with multi waler cpl. can be used anywhere you need a single-sided waler up to a height of 1.50m and would like to use multi walers 140 instead of a supporting jack 1.50m.

Easy assembly

A supporting jack can be assembled from the connecting piece and two multi walers 140. This is done in a few quick and easy steps. First, put a suspending piece for props to each multi waler. Then insert the connecting piece between the two multi walers. Secure the whole thing with the pre-assembled tube locking pins and security pins. Finally, connect the two multi walers diagonally with a strut through the attached suspending pieces for props. The flexible hinge of the connecting piece allows you to extend or retract the strut as required if an inclination of +/- 15° is needed. The ground anchoring with the Combi V-guide is the same as for the common application of a support jack.

For further system advantages, please refer to the technical information.