LOGO.3 panel 90 x 340 cm

The LOGO.3 panel 90 x 340 cm is a formwork panel in the PASCHAL LOGO.3 formwork range.

Measuring 90 x 340 cm, this is one of the widest compensation panels for a formwork height of 3.40 m, along with the multi-purpose panel. In addition to the extremely strong, profiled flat steel frame, the panel comprises a birch plywood sheet which is supported by nine multifunctional cross hat profiles.

• Made of profiled, very strong flat steel
• 16 mm Finnish birch plywood, 12 ply
• Fresh concrete pressure absorption of 70 kN/m² compliant with DIN 18218
• Ideal for exposed concrete due to the narrow frame imprint in the concrete
• Safe and rapid connection with the wedge clamp
• Compliance with maximum safety standards thanks to the lateral protection system Secuset
• LOGO.3 is also available in your corporate colours
• Transponders for clear identification
• Vertical and horizontal use

Application information

The PASCHAL LOGO.3 panel 90 x 340 cm can be used anywhere, whether for large-scale forming or for concreting a small but complicated ground plan. Only very few connecting pieces are required for large wall areas, resulting in outstanding forming times.

In addition, the LOGO.3 panel 90 x 340 cm satisfies the stringent requirements for concrete surfaces, as only an extremely narrow frame imprint is left in the concrete.

When combined with the LOGO foundation tie clamp, the LOGO.3 panel 90 x 340 cm can also be used as foundation formwork.

Comprehensive occupational safety

Thanks to its ease of use, the lateral protection system Secuset can be installed safely and efficiently on formwork. The LOGO concreting platform can be secured to the panels as a working platform in order to ensure safe working.

Special features of the 340 cm-high panel

The 340 cm-high LOGO panel has holes for ties at the same height as the 270 cm LOGO panel. The 270 cm-high panel can therefore be located opposite the 340 cm-high panel and braced using tie rods. This formwork that is higher on one side can then be used as slab edge formwork. This option is used particularly often for lift cores. Outer formwork of 270 cm, inner core formwork of 340 cm, this then remains in the lift core as slab edge formwork up until the slab formwork is concreted.

Two tie points are sufficient for the panel height for concreting heights up to 340 cm. If the 340 cm-high LOGO panel is extended in height, the number of tie points is increased to just three for the panel height.

LOGO.3 satisfies customer requirements

To increase your recognition value, the PASCHAL LOGO.3 formwork can be produced in your corporate colours on request.
In addition, thanks to the PASCHAL ident technology, our transponders uniquely identify each LOGO.3 panel.

Please refer to the technical information for further system benefits.