LOGO multi-purpose panel 90 x 340 cm

The LOGO. 3 multi-purpose panel 90 x 340 cm is one of the panels with the broadest range of applications within the LOGO.3 formwork system.

Together with the formwork panel 90 x 340 cm it is the widest compensation panel for a formwork height of 3.40 m. In addition to the extremely strong, profiled flat steel frame, the panel comprises a birch plywood sheet which is supported by seven multifunctional top hat profiles and four multi-hole profiles.

• Made of profiled, very strong flat steel
• 16 mm Finnish birch plywood, 12 ply
• Fresh concrete pressure absorption of 70 kN/m² compliant with DIN 18218
• Multi-purpose panel for a very diverse range of applications
• Additional tie positioning option
• Safe and rapid connection with the LOGO locking screw
• Compliance with maximum safety standards thanks to the lateral protection system Secuset
• LOGO.3 is also available in your corporate colours
• Transponders for clear identification

Application information

The LOGO.3 multi-purpose panel 90 x 340 cm can be used for a very wide range of applications. The additional hole profiles enable it to be used with the LOGO locking screw for:

• 90° corners
• Columns
• Stop ends

Thanks to the additional multi-hole profiles, the ties can also be positioned as follows:

• For lengthwise connections on existing walls
• For crosswise connections on existing walls
• For vertical connections on existing walls

Comprehensive occupational safety

Thanks to its ease of use, the lateral protection system Secuset can be installed safely and efficiently on wall formwork. The LOGO concreting platform can also be secured to the panels as a working platform. The Grip working platform is ideal for column formwork.

Special features of the 340 cm-high panel

The 340 cm-high LOGO panel has holes for ties at the same height as the 340 cm LOGO panel. The 340 cm-high panel can therefore be located opposite the 340 cm-high panel and braced using tie rods. This formwork that is higher on one side can then be used as slab edge formwork. This option is used particularly often for lift cores. Outer formwork of 340 cm, inner core formwork of 340 cm, this then remains in the lift core as slab edge formwork up until the slab formwork is concreted.

Two tie points are sufficient for the panel height for concreting heights up to 340 cm. If the 340 cm-high LOGO panel is extended in height, the number of tie points is increased to just three for the panel height.

LOGO.3 satisfies customer requirements

To increase your recognition value, the PASCHAL LOGO.3 formwork can be produced in your corporate colours on request. In addition, thanks to the PASCHAL ident technology, our transponders uniquely identify each LOGO.3 panel.

Please refer to the technical information for further system benefits.

 Discover now virtually

 Watch our product video