Deutsch
English
Francais
Ball-and-socket joint plate DW15 10x14 cm inclination max. 12 degrees
The PASCHAL ball-and-socket joint plate DW15 10x14 cm is used as a connecting piece for our DW15 tie rods in all formwork systems.
- Consisting of joint nut and support plate 10 x 14 cm | nut with DW15 thread
- The bearing plate can be inclined up to 12°
- Permissible anchor force 90 kN | 1.29 kg light
- Quick assembly and disassembly
- Cast forging with fully chromated surface
- Easy to operate from the front
- Integrated nail hole
Application information
The ball-and-socket joint plate DW15 10x14 cm is used wherever stressing points are required. These are used to transfer the force of the concrete pressure via the formwork to the tie rods.
Assembly is carried out by inserting a DW15 tie rod through the clamping point opening provided for this purpose. The tie rod must then be fixed from both sides with the ball-and-socket joint plate. The ball-and-socket joint plate is screwed onto the tie rod by the nut with DW15 thread until the bearing plate rests on the panel frame.
For LOGO compensation and NeoR panels, the ball-and-socket joint plates ensure that both panels are held, as the clamping points are located at the panel joint.
Easy to use
The two wings of the nut allow the ball-and-socket joint plate to be easily operated with a hammer. To remove, the ball joint plate can also be loosened and unscrewed with a hammer blow.
Please refer to the relevant technical information for the various applications, quantities and arrangements of the ball-and-socket joint plates.
